You can now purchase our new 2015 Component Stereo Console only and install your own radio head unit and speakers. This console can be used on many UTV;s, Side-By-Side machines, such as; Polaris 2014 and current RZR 900-1000 2 seat and 4 seat models, Kawasaki Mule 2 and 4 seat models, and more.
We manufacture a complete mounting kitS for many popular models, see OPTIONS. These units are also able to be used on most Golf Carts and UTV's with flat metal or plastic roofs. There are (5) re-enforced mounting pads to bolt to that make it easy to mount and or fabricate spacers and or mounting plates.
We currently manufacture several mounting kits for different UTV's (SEE OPTIONS) and we can also manufacture you a custom mounting kit upon request if your machine meets a few simple requirements, see below for details.
The photo's show typical mounting methods using our custom made mounting kits available for many popular machines, SEE OPTIONS.
Just What is a Component System?
Component systems are such that use multiple speakers such as; woofers, mid range, and or tweeters in combination which provides a greater range of sound wave frequencies, which results in a higher quality of sound. Your home stereo or theater systems are built as component systems with speakers as such. If you are a music lover and care about the highest quality of sound, this is the system for your machine.
An expansion system that will bolt just behind this unit is available with an additional (4) 6.5" rear speakers making this a 6- speaker full range system.
This unit has also been designed to be able to be mounted to a flat roof with (5)1/4" threaded mounting (studs / points).
This unit has been designed to be mounted in the center of the vehicle and poses no windshield viewing restrictions. The body of the console is less than 3.5" in height, and when mounted the majority of the unit is only 4.25" from the top to the bottom. The radio head unit is in the center of the console is out of the way of your head and view both driver and passenger, but easy to view and set at the best angle for optimum viewing and adjusting.
We are offering this unit with the following factory work performed, however see the OPTIONS boxes to have us customize a unit with specific features.
INCLUDED WITH THIS PURCHASE
- CONSOLE TOP AND BOTTOM ASSEMBLED W/ FOAM RUBBER SEAL
- RADIO HEAD UNIT POD / CUT-OUT FOR SINGLE DIN RADIO UNIT
- 2- 1" TWEETERS (LEFT AND RIGHT) with CROSS-OVER PROTECTION
- FACTORY WIRED / MASTER SWITCH, FUSE HOLDER, LED SWITCH
- 12" TUBELOOM LED CAB LIGHT INSTALLED
- STAINLESS STEEL ASSEMBLY BOLTS / THREADED MOUNT STUDS
We will only cut the speaker holes on request, SEE OPTIONS. You must let us know the O.D. of the speaker hole to be cut, if you are not sure opt for the 5" diameter which is very common for many 6.5" speakers, the hole can be easily enlarged if necessary with a rotary drum sander and a drill.
- DURABLE AND STYLISH ABS THERMAL FORMED HOUSING
- LOW PROFILE ORIGINAL DESIGN
- RAISED GRAIN BLACK FINISH
- REMOVABLE SEALED BACK
- COMPONENT DESIGN RECESSED 7" AND 2.5" SPEAKER AREAS
- LED CAB LIGHT BY TUBELOOM W/SWITCH
- MASTER POWER SWITCH FOR RADIO HEAD UNIT
- ACCESSIBLE FUSE HOLDER W/5 AMP FUSE
- REMOVABLE RADIO POD FOR EASY SERVICE
- FACTORY WIRED AND TESTED
- REAR MATCHING POD FOR (2) REAR SPEAKERS AVAILABLE (See Options)
- MADE IN THE USA
- LENGTH- (RIGHT TO LEFT) 31.0"
- WIDTH- (FRONT TO BACK) 14.0"
- HEIGHT- (RIGHT AND LEFT SIDE) 4.0"
- HEIGHT- (CENTER RADIO UNIT) 8.0" ( Maximum center point )